Winter fuel
When Does Diesel Gel? Cloud Point, Gel Point and Colorado Winters
There is no single number. Diesel clouds, then plugs a filter, then gels, and an ordinary January night in Denver can be cold enough for the first step.
By Bodacious Diesel, Golden, CO. Updated November 2026. 6 min read.
Ask ten truck owners when diesel gels and you will hear ten different numbers. The honest answer is that it depends on what is in your tank. The National Renewable Energy Laboratory's Biodiesel Handling and Use Guide puts the cloud point of diesel fuels anywhere from -31 F to 23 F. That 54 degree spread is why one truck starts fine on a cold morning and the one parked next to it does not.
Around Golden and the Denver metro, the warm end of that range is the one that matters. The National Weather Service lists Denver's normal January low at 18 to 19 F. Fuel blended for warmer months can start clouding on a normal winter night, not only during a record cold snap.
The short version
Diesel does not gel at one temperature. Wax crystals form at the cloud point, start plugging the fuel filter a few degrees colder, and turn the fuel to gel at the pour point.
Untreated #2 diesel clouds first. #1 diesel and winter blends hold out far longer. Biodiesel blends cloud a little sooner.
Three temperatures, not one
Diesel carries paraffin wax that stays dissolved while the fuel is warm. As the fuel cools, that wax comes out in stages, and NREL's guide defines each one.
| Stage | What happens in the fuel | What you notice |
|---|---|---|
| Cloud point | The first small wax crystals appear as the fuel cools | Nothing yet. Fuel in a clear jar looks hazy |
| Filter plugging point | Crystals build up until fuel can no longer pass through a standard filter in the test time | Long crank, stalls a few minutes after starting, power drops under load |
| Pour point (gel) | So many crystals have bonded that the fuel is essentially a gel and no longer flows | No start. Fuel will not move through the lines |
Source: NREL, Biodiesel Handling and Use Guide, Sixth Edition.
The filter is where the trouble starts, because it catches crystals long before the fuel turns solid. On most trucks the first sign of cold fuel is a clogged filter, not a tank full of jelly, and a plugged filter, a strained lift pump and a starved injection pump are the everyday work of diesel fuel system repair.
#1 vs #2 diesel, and what winter blend means
#2 diesel is the standard pump fuel. #1 diesel is a lighter fuel, close to kerosene, and NREL lists cloud points for kerosene and Jet A of -40 F to -60 F. Winter blend is #2 with #1 mixed in, a cold flow additive, or both, so it stays liquid at lower temperatures.
Suppliers do not guess at the mix. The appendix to ASTM D975, the diesel fuel standard, lists a tenth percentile minimum temperature for each state and month: the temperature that, on average, only 10 percent of days fall below. Many distributors blend winter fuel to that number. Winter blend covers most nights by design, not every night, so a cold snap below that line can still gel fuel that was blended correctly.
Timing matters too. Fuel you bought in September and parked on through the first hard freeze is fall fuel. A truck that sits for weeks, or a spare tank at a shop or ranch, can carry warm-weather fuel well into winter.
Biodiesel blends cloud a little sooner
If your truck runs a biodiesel blend such as B20, which is 20 percent biodiesel, plan for a slightly higher cloud point. The Clean Fuels Alliance America says a B20 blend can cloud about 2 to 7 F higher than straight #2 diesel, while B5 stays close to #2.
NREL recommends keeping blends at least 5 to 10 F above their cloud point. A truck parked outside in the foothills cannot always manage that, which is one more reason to treat the fuel before a cold front arrives, not after.
What cold fuel does to the truck
A filter packed with wax starves everything behind it. The lift pump works harder, supply pressure drops, and the high pressure pump runs short of the fuel it uses for both injection and lubrication. Late-model pumps such as the Bosch CP4 have little tolerance for running short, and a truck that keeps cranking against gelled fuel can turn a cold morning into diesel injection pump repair.
Watch for a crank that runs longer than usual, an engine that starts and then stalls, a rough idle, or a loss of power on the first grade out of town. Most modern diesels have a fuel heater at the filter, but it can only do so much when the fuel in the tank and lines has already clouded.
If your truck already gelled
Stop cranking. Every extra attempt runs the pumps short of fuel and drains the batteries. The fuel has to warm back above its cloud point, which means a heated building, never a heat gun or open flame near the fuel system.
Anti-gel additive is prevention. It has to be in the tank before the fuel gets cold, and it will not undo fuel that has already gelled. After a gelling event the fuel filter usually needs to be replaced, and the truck should not go back on a mountain grade until fuel pressure has been checked.
If the truck will not start or keeps stalling, have it brought to the shop rather than forcing it. We warm it up, replace the filters, and check supply pressure and the injection pump before it goes back to work.
Diesel gelling questions
Does diesel fuel freeze?
Not the way water does. Diesel turns cloudy as wax crystals form, then thickens into a gel at its pour point. It plugs filters well before it becomes solid.
At what temperature does diesel gel?
It depends on the fuel. NREL lists diesel cloud points from -31 F to 23 F. Untreated #2 diesel sits at the warm end, while #1 diesel and winter blends sit far lower.
Can winter blend diesel still gel?
Yes. Winter blend is usually made for the month's tenth percentile low temperature, so a colder than usual night can still push it past its limit.
Diesel stalling or won't start in the cold?
Bodacious Diesel has worked on Power Stroke, Duramax and Cummins trucks in Golden since 2007. Call the shop and tell us what the truck is doing.
Call (303) 808-1563


